SAFER BOARDING

Since 1991, Warm Welcome® low voltage step heaters have been used throughout North America in major city transit systems that provide services in cold weather. These same snow-melting heaters have been installed on airport shuttles, school buses, passenger trains, and even on off-shore oil platforms in the North Sea. You’ll find Warm Welcome® low voltage step heaters from  NYC to Toronto, Toledo to Washington DC, Cleveland to Spokane and many more metropolitan areas.

EASY TO INSTALL

With a thin profile and zero moving parts WARM WELCOME® Step heaters can easily be installed (at the factory or retrofitted to existing vehicles) beneath the treads of any size steps or lifts.  Each one is pre-wired for quick and easy installation.  The step treads are environmentally friendly replacing corrosive salts and potentially damaging de-icing chemical to preserve the steps of your vehicles and save on maintenance.

Whatever your specific transit requirements, WARM WELCOME® can help your passengers board and debark with more safety.  Manufacturers offer the step heaters pre-installed at the factory. However, retrofitting is not a problem for after-market installations in existing vehicles and fleets.  The step heaters come pre-wired, install quickly, and work beneath any size step or lift.

RETROFITTING IS POSSIBLE!

HOW THEY WORK FOR MASS TRANSIT

Your commercial vehicles will be safer for boarding and debarking, so your passengers won’t be concerned about snow or ice covered steps.  When safety matters, depend on our time-saving, proven solution to give your passengers a safer, more welcoming ride. Whatever your specific transit requirements, WARM WELCOME® can help your passengers board and debark with more safety. Manufacturers offer the step heaters pre-installed at the factory.

Retrofitting is not a problem for after-market installations in existing vehicles and fleets. The step heaters come pre-wired, install quickly, and work beneath any size step or lift.

Mass Transit step heaters are built with a thin profile and are installed between the transit vehicles’ factory step treads, and the floor. The top layer floor tread overlays the foil-covered heat element while the bottom (also foil-covered) lays flat against the vehicle floor. In this manner, the look and feel of the vehicle step is preserved while the heater is protected and your passengers are ensured a comfortable step.

WATCH EVERY STEP

To speak with one of our engineers call (888) 437-3003 or email any time.

TOLL FREE

1.888.437.3003

ORDER NOW

509.466.2502

OFFICE HOURS

8:00 am – 3:30 pm

TOLL FREE

1.888.437.3003

ORDER NOW

509.466.2502

OFFICE HOURS

8:00 am – 3:30 pm